Sand around the damaged area so there is no lettering, raised area or lugs where the patch will lay.

Hold the cut back together for 1 minute to allow for a cure. Once dried, lightly re-sand to remove dried excess adhesive.

Use a patch to cover the damaged area, ensure there is at least 1/2" of patch all around the puncture/damage.

This can be done on the patch or the tire. Follow glue pattern in the instructions. Immediately set the patch in place and apply pressure.

Hold the patch with even pressure 3 minutes. Ensure corners and edges are fully adhered.

Air up tire, check for leaks. If leak is found, remove air from tire and add adhesive as needed. Inflate and ride!